SUPER MICRO Computer X6DHi-G2 - Manual (Page 23)

Chapter 2: Installation
2-3
CEK Passive Heatsink
Screw#1 Screw#2
Screw#1
1. Do not apply any thermal grease to
the heatsink or the CPU die-the required
amount has already been applied.
2. Place the heatsink on top of the CPU so
that the four mounting holes are aligned
with those on the retention mechanism.
3. Screw in two diagonal screws (ie the #1
and the #2 screws) until just snug (-do not
fully tighten the screws to avoid possible
damage to the CPU.)
4. Finish the installation by fully tightening
all four screws.
CEK Heatsink Installation
Screw#2