SUPER MICRO Computer X6DHi-G2 - Manual (Page 27)

Chapter 2: Installation
2-7
DDR 2 Slot
Release Tab
Release Tab
To Remove:
Use your thumbs to gently push near the edge of both ends of the
module. This should release it from the slot.
2-4 I/OPorts/Control Panel Connectors
The I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 2-3 below for the colors and locations of the various I/O ports.
Figure 2-3. I/O Port Locations and Defi nitions
Video
Figure 2-2. Installing and Removing DDR 2
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Pay attention
to the align-
ment notch at
the bottom. 2