Sanyo PLC-WXE45 - Manual (Page 9)

9
Rear Terminal
S-VIDEO IN
MONITOR OUT
COMPUTER IN 2 /
COMPUTER /
COMPONENT
AUDIO IN
R
VIDEO IN L
(MONO)
(VARIABLE)
AUDIO OUT
① ② ③ ④ ⑤ ⑥
⑧
⑦
⑤ S-VIDEO IN
Connect the S-VIDEO output from video equipment
to this jack (p.15).
⑥ AUDIO IN
Connect the audio output from video equipment
connected to
⑤ or ⑨ to this jack. [When the audio
output is monaural, connect it to L (MONO) jack
(p.15).
⑧ COMPUTER/COMPONENT AUDIO IN
Connect the audio output (stereo) from a computer
or video equipment connected to
① or ④ to this
jack (pp.14, 16).
⑨ VIDEO IN
Connect the composite video output from video
equipment to VIDEO jack (p.15).
④ COMPUTER IN /MONITOR OUT
This terminal is switchable and can be used
for input from a computer or output to the other
monitor.
Set the terminal up as either Computer input or
Monitor output properly. [Used for Monitor out,
this terminal outputs only incoming signal from
COMPUTER IN 1/COMPONENT IN terminal (pp.
14, 44)].
⑦ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.14 - 16).
This terminal outputs sound from AUDIO IN
terminal (
⑥ or ⑧ ).
②
SERVICE PORT
When controlling the projector from a computer,
connect the computer to this connector with a
control cable.
① COMPUTER IN 1/COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output, or component video output to
this terminal (pp.14, 16).
When the cable is of the longer variety, it is
advisable to use this terminal and not COMPUTER
IN 2/MONITOR OUT.
⑨
Part Names and Functions
③ LAN Connection Terminal
Connect the LAN cable (Refer to the owner's
manual of "Network Set-up and Operation".).