Sanyo PLC-WXE45 - Manual (Page 6)

Movin� the Projector
When moving the projector, replace the lens cover and
retract the adjustable feet to prevent damage to the lens
and cabinet. When the projector is not in use for an
extended period, put it into a suitable case.
Handle the projector carefully; do not drop, bump,
subject it to strong forces, or put other things on the
cabinet.
Do not roll the projector more than
20 degrees from side to side.
Do not point the projector up to
project an image.
Do not point the projector down to
project an image.
Do not put the projector on either
side to project an image.
Install the projector properly. Improper Installation may
reduce the lamp life and cause fire hazard.
Installin� the Projector in Proper
Position
Openings in the cabinet are provided for ventilation. To
ensure reliable operation of the product and to protect it
from overheating, these openings must not be blocked
or covered.
Air Circulation
Air Intake
Vent
Exhaust Vent
(Hot air exhaust)
Exhaust Vent
(Hot air exhaust)
Air Intake
Vent
CAUTION
Hot air is exhausted from the exhaust vent. When
using or installing the projector, the following
precautions should be taken.
– Do not put any flammable objects or spray can
near the projector. Hot air is exhausted from the air
vents.
– Keep the exhaust vent at least 3’ (1 m) away from
any objects.
– Do not touch a peripheral part of the exhaust vent,
especially screws and metallic part. This area will
become hot while the projector is being used.
– Do not put anything on the projector. Objects put on
the cabinet will not only get damaged but also may
cause fire hazard by heat.
Cooling fans are provided to cool down the projector.
The fan’s running speed is changed according to the
temperature inside the projector.
CAUTION IN CARRYING OR
TRANSPORTING THE PROJECTOR
– Do not drop or bump the projector, otherwise
damages or malfunctions may result.
– When carrying the projector, use a suitable carrying
case.
– Do not transport the projector by courier or any other
transport service in an unsuitable transport case. This
may cause damage to the projector. For information
about transporting the projector by courier or any
other transport service, consult your dealer.
– Do not put the projector in a case before it is cooled
enough.
Do not pitch the projector more
than 20 degrees backward and
forward.
Safety Instructions
CAUTION
Choose the running speed of cooling fans in the fan
control setting according to the altitude in which the
projector is being used (p.49). Failure to do so may
affect the projector life.