Sanyo PLC-WXE45 - Manual (Page 51)

51
How to Use the Antitheft Alarm Function
The Antitheft alarm function is to prevent the projector from being stolen. With this function on, the alarm rings
when an unauthorized person tries to move the projector.
Press the F button twice to turn the alarm function on. The
ALARM indicator blinks for a few seconds and the projector
enters the warning mode.
While the Antitheft alarm function is on, the projector emits a
low-pitched sound when detecting a vibration.
When the projector does not detect a vibration for a few
seconds after the sound, it goes back to the warning mode.
When the projector detects more vibrations after the low-
pitched sound, the alarm starts ringing.
Set the alarm
Release the alarm settin�
Note:
• This function is not a guarantee against stealing.
• The alarm does not ring while the AC power cord is
connected even if the projector detects vibrations.
• Pressing the button is always accompanied by a sound.
If any sound is not produced after pressing the button,
you need to press it again.
Side Control
ALARM
indicator
F button button 1, ,
Set and release the Antitheft alarm function
Note:
• You can test the alarming sound without setting the
alarm. Press and hold the F button then the alarm starts
ringing. The length of the ringing time is what you set on
the "Ringing time". (p. 48)
• If you want to stop the alarm while it is ringing, insert the
AC power cord or press the F button and enter the four-
digit PIN code.
Before operating the Antitheft alarm function, install a
battery in the projector. (see p. 53 for installation)
Install a battery
1
Press the F button and enter the four-digit PIN code
within about 10 seconds. (The default PIN code is
"1111".) When the alarm is released, you hear high-
pitched confirmation sound.
When entering an incorrect PIN code, you hear low-
pitched sound. If you enter an incorrect PIN code 3
times, the alarm starts ringing.
Antitheft Alarm Function