Sanyo PLC-WXE45 - Manual (Page 17)

CAUTION
The AC outlet must be near this equipment and must be easily
accessible.
Connectin� the AC Power Cord
Connect the AC power cord (supplied) to the
projector.
17
Note:
Unplug the AC power cord when the projector is not in
use. When the projector is connected to an outlet with the
AC power cord, it is in stand-by mode and consumes a
little electric power.
Installation
This projector uses nominal input voltages of 100–120 V
or 200–240 V AC and it automatically selects the correct
input voltage. It is designed to work with single-phase power
systems having a grounded neutral conductor. To reduce
the risk of electrical shock, do not plug into any other type of
power system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service station.
Connect the projector with all peripheral equipment before
turning it on.
To power cord
connector on your
projector.
Projector side AC outlet side
Ground
To the AC outlet.
(10 V AC)
For Continental Europe For the U.S.A. and Canada For the U.K.
To the AC outlet.
(00–40 V AC)
To the AC outlet.
(00–40 V AC)
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.