Sanyo PLC-WXE45 - Manual (Page 45)

Power mana�ement
Time left before Lamp is off.
Press the SELECT button
at Power management and
this box appears. Select
one of three settings with
the Point ◄► buttons, and
go to the timer with the
Point ▲▼ buttons and set
time with the Point ◄►
buttons.
Power mana�ement
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the input signal is interrupted and no
button is pressed for a certain period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display with
“No signal” appears. The countdown starts to turn off the
lamp.
Select one of the operations.
Ready……… When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp is turned on if the input
signal is reconnected or any button on the
remote control is pressed.
Shut down… When the lamp has been fully cooled down,
the power is turned off.
Off………… Power management function is off.
Then set the countdown timer with the Point ◄► buttons.
45
Note:
Factory default is “Ready: 5 min.”
Settin�
Standby mode
This function is available when operating the projector via
network.
Normal........ Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered
off.
Eco............. Select “Eco” when you do not use the projector
via network. The projector’s network function will
stop when turning off the projector.
Refer to the owner’s manual “Network Set-up and Operation”.