Sanyo PLC-WXE45 - Manual (Page 34)

Select Video by pressing the VIDEO button on the remote
control.
Before using VIDEO button, select the correct input source
through menu operation as described below.
Use the MENU button to display the On-Screen Menu.
Press the Point ◄► buttons to move the red frame
pointer to the Input Menu icon.
Use the Point
▲▼ buttons to move the red arrow
pointer to Video and then press the SELECT button to
display the Source Select Menu .
1
2
VIDEO
Move the pointer to the
desired source and press
the SELECT button.
Source Select Menu (VIDEO)
Input Menu
Move the pointer to the desired source and then press
the SELECT button.
3
When selecting “Auto,” the projector
automatically detects the incoming video signal,
and adjusts itself to optimize its performance.
The projector selects connection in the following
order:
1. S-video
2. Video
Auto
When the video input signal is connected to the
VIDEO jack, select Video.
Video
When the video input signal is connected to the
S-VIDEO jack, select S-video.
S-video
Input Source Selection (Video, S-video)
Direct Operation
Menu Operation
Input Menu icon
Remote Control
VIDEO button
Note:
• Computer 2 is not displayed when the COMPUTER IN
2/MONITOR OUT terminal is set as Monitor out (p.44).
•When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.44).
4
Video Input
Move the pointer to Video and
press the SELECT button.
Video