Sanyo PLC-WXE45 - Manual (Page 61)

1
The CE Mark is a Directive
conformity mark of the European
Community (EC).
WARNING :
Hi�h volta�es are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Specify the model number and explain about the problem. We will advise you
how to obtain service.
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.
Indicator blinks or li�hts.
– Check the status of the projector with referring to "indicators and Check the status of the projector with referring to "indicators and
Projector Condition" (see page 64).
Alarm does not stop rin�in�.
– Connect the AC power cord to the AC outlet. (Alarm will not stop Connect the AC power cord to the AC outlet. (Alarm will not stop
ringing when the alarm goes off while trying to remove the battery
cover.) (see pages 51-53).
Alarm rin�s even when the warnin�
mode is turned off.
– The battery may be coming to the end of its life. Replace the The battery may be coming to the end of its life. Replace the
battery with a new one promptly.
Warnin� mode is not turned on.
– If you cannot hear the bleeping sound when you press the Alarm If you cannot hear the bleeping sound when you press the Alarm
buttons, you are not pressing the buttons correctly. Try to set the
Alarm setting again (see page 51).
Computer cannot be selected.
– Select Computer 2 in the Terminal function (see page 44). Select Computer 2 in the Terminal function (see page 44).
The terminal function cannot be
selected.
– The Terminal function cannot be selected after Computer 2 is The Terminal function cannot be selected after Computer 2 is
selected. Select other input source such as Computer 1 or Video
with the COMPUTER button or the VIDEO button on the remote
control so that the Terminal function can be selected.
The exclamation mark appears on
the screen.
– Your operation is invalid. Operate correctly. Your operation is invalid. Operate correctly.
Unable to unlock the Lo�o PIN code
lock or Security PIN code lock.
– Contact the dealer where you purchased the projector or the Contact the dealer where you purchased the projector or the
service center.
Appendix
Pixelworks ICs used.