Sanyo PLC-WXE45 - Manual (Page 42)

Capture
This function enables you to capture the image being
projected and use it for a start-up display or interval of
presentations.
After capturing the projected image, go to the Logo select
function and set it to “User.” Then the captured image is
displayed when the projector is turned on next time or the
NO SHOW button is pressed (p 24).
To capture the image, select “Yes.” To cancel the Capture
function, select “No.”
Select "Yes" to capture
the projected image.
Select "Yes" to
stop capturing.
Capture
Logo select
This function decides the start-up display as follows:
User………The image you captured
Default……The factory-set logo
Off…………Countdown only
Logo (Logo and Logo PIN code lock settings)
This function allows you to customize the screen logo with
Logo select, Capture, and Logo PIN code lock functions.
Logo select
Note:
When “On” is selected in Logo PIN code lock function,
Logo select and Capture functions cannot be selected.
Note:
• Before capturing an image, select "Standard" in the
Image Select Menu to capture a proper image (pp.30,
37).
• A signal from a computer can be captured up to
WXGA(1280 x 800). A signal from video equipment
can be captured except for 720p, 1035i, and 1080i.
• When you capture the image that has been adjusted
by the Keystone or the Custom function, the adjusted
data is automatically reset and the projector captures
an image without keystone or custom adjustment.
• When the Logo PIN code lock function is “On,” Capture
menu cannot be selected.
• When you start to capture a new image, the previously
stored image is cleared even if you cancel the
capturing.
• “User” cannot be selected when the image is not
captured.
42
Setting