Installation, Positioning the projector, Adjustable feet – Sanyo PLC-WXE45 User Manual
Page 13: Installation 1, Adjustable feet positionin� the projector
Note:
•This projector is not equipped with an optical zoom. To adjust the screen size, change the throw distance.
• The brightness in the room has a great influence on picture quality. It is recommended to limit the ambient
lighting in order to get the best image.
•All measurements are approximate and may vary from the actual sizes.
50”
80”
110”
A
3.927’ (119.7 cm)
2.826’ (86.1 cm)
1.726’ (52.6 cm)
(Inch Diagonal)
For the projector positioning, see the figures below.
The projector should be set perpendicularly to the plane of the screen.
Projection angle can be adjusted up to 10.0 degrees with
the adjustable feet.
Lift the front of the projector and pull the feet lock latches
on both sides of the projector upward.
1
Adjustable Feet
Feet Lock Latches
Release the feet lock latches to lock the adjustable feet
and rotate the adjustable feet to adjust the position and
tilt.
2
To retract the adjustable feet, lift the front of the projector
and pull and undo the feet lock latches.
Keystone distortion of the projected image can be
corrected by remote control operation or menu operation
(pp.22, 41).
3
Adjustable Feet
Positionin� the Projector
Installation
1
Screen Size
(W x H) mm
16:10aspect ratio
50”
80”
110”
1077 x 673
1723 x 1077
2369 x 1481
Throw distance 1.726’ (52.6 cm) 2.826’ (86.1 cm) 3.927’(119.7 cm)
A
0.623’ (19.0 cm) 0.846’ (25.8 cm) 1.069’ (32.6 cm)