Silicon Laboratories SI2493/57/34/15/04 - Manual (Page 172)

A N 9 3
172 Rev. 1.3
Table 108. AT+PQC Parameters
Description
0 Enable Short Phase 1 and Short Phase 2
1 Enable Short Phase 1
2 Enable Short Phase 2
3 Disable Short Phase 1 and Short Phase 2
Table 109. AT+PSS Parameters
Description
0 The DCEs decide whether or not to use
the short startup procedures. The short
startup procedures shall only be used if
enabled by the +PQC command.
1 Forces the use of the short startup proce-
dures on the next and subsequent con-
nections if they are enabled by the +PQC
command.
2 Forces the use of the full startup proce-
dures on the next and subsequent con-
nections independent of the setting of the
+PQC command.