Sun Microsystems Netra 120 - Manual (Page 45)

Chapter 3 Using DC Power 3-7
3.2.3 Installing the Strain Relief Housings
1. Insert the bottom portion of the strain relief housing into the notch on the DC
connector until it snaps into place (see FIGURE 3-6 ).
Make sure that the strain relief housing snaps into place on the DC connector,
otherwise you will not be able to complete the assembly correctly.
FIGURE 3-6 Inserting the Bottom Portion of the Strain Relief Housing
2. Route the three wires coming from the DC power source through the opening at
the end of the bottom portion of the strain relief housing (see FIGURE 3-7 ).