Sun Microsystems Netra 120 - Manual (Page 170)

11-16 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
10. Replace the Fan 3 assembly by screwing the ducting back into the chassis and
connecting the fan’s power cable into the connector on the new system board
(see
FIGURE 11-8 ).
FIGURE 11-8 Replacing the Fan 3 Assembly
11. Replace the PCI card if you removed it (see Section 4.6.1, “Installing a PCI Card” on
page 4-11).
12. Slide the system board protection/support block forward until it engages with the
the system board (see FIGURE 11-7 ).
Tighten the screw to fix the block to the chassis.
13. Reconnect all system board cables.
14. Replace the server’s cover and tighten the captive screw (see FIGURE 4-9 in
Section 4.7, “Replacing the Server’s Top Cover” on page 4-14).
15. Replace the front bezel.