Sun Microsystems Netra 120 User Manual
Page 181

Appendix A
Installing and Removing a SCSI Hard Disk Drive with Solaris Running
A-3
3. Connect the new disk logically to the Operating System by typing the following
command, specifying the correct
Ap_Id
label for the disk you have installed (in
this sample command the
Ap_Id
label is for Disk 1):
4. Confirm that the disk is now connected and configured by typing:
5. If you want to check that the disks are active, follow the instructions in
The disk is now available to be mounted for operation.
# cfgadm -c configure c1::dsk/c1t1d0
# cfgadm -al
Ap_Id
Type
Receptacle
Occupant
Condition
c0
scsi-bus
connected
configured
unknown
c0::dsk/c0t0d0
CD-ROM
connected
configured
unknown
c1
scsi-bus
connected
configured
unknown
c1::dsk/c1t0d0
disk
connected
configured
unknown
c1::dsk/c1t1d0
disk
connected
configured
unknown
c2
scsi-bus
connected
unconfigured
unknown