Sun Microsystems Netra 120 - Manual (Page 43)

Chapter 3 Using DC Power 3-5
6. Insert the tip of the cage clamp operating lever into the rectangular hole directly
above the hole in the DC connector where you want to insert the first wire.
Then press down on the cage clamp operating lever (see FIGURE 3-3 ). This opens the
cage clamp for this section of the DC connector.
You can also open the DC connector cage clamp by inserting a small slotted
screwdriver into the rectangular hole directly above the hole in the DC connector
where you want to insert the first wire, and then pressing down on the screwdriver
(see
FIGURE 3-4 ).
FIGURE 3-3 Opening the DC Connector Cage Clamp (Lever Method)