2 additional diagnostic tests for specific devices, Additional diagnostic tests for specific devices, Using the – Sun Microsystems Netra 120 User Manual
Page 148

10-8
Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
10.2
Additional Diagnostic Tests for Specific
Devices
10.2.1
Using the
probe-scsi
Command To Confirm
That Hard Disk Drives Are Active
The
probe-scsi
command transmits an inquiry to SCSI devices connected to the
system’s internal SCSI interface. If a SCSI device is connected and active, the
command displays the unit number, device type, and manufacturer name for that
device.
The
probe-scsi-all
command transmits an inquiry to all SCSI devices connected
to both the system’s internal and its external SCSI interfaces.
shows
sample output from a Sun Fire V120 with no externally connected SCSI devices but
containing two 36 GB Hard Disk Drives, both of them active.
FIGURE 10-2
probe-scsi
Output Message
ok probe-scsi
Target 0
Unit 0 Disk SEAGATE ST336605LSUN36G 4207
Target 1
Unit 0 Disk SEAGATE ST336605LSUN36G 0136
FIGURE 10-3
probe-scsi-all
Output Message
ok probe-scsi-all
/pci@1f,0/pci@1/scsi@8,1
/pci@1f,0/pci@1/scsi@8
Target 0
Unit 0 Disk SEAGATE ST336605LSUN36G 4207
Target 1
Unit 0 Disk SEAGATE ST336605LSUN36G 0136