Sony Ericsson GM47 - Manual (Page 97)

2. CALL CONTROL
97
LZT 123 7263 R1C
2.11 AT+CMOD Call Mode
Selects the call mode of further dialing commands (D) or for next
answering command (A). Mode can be either single or alternating. In
this ETS, terms “alternating mode” and “alternating call” refer to all
GSM bearer and teleservices that incorporate more than one basic
service (voice, data, fax) within one call.
When single mode is selected the call originating and hang-up
procedures are similar to procedures specified in ITU-T
Recommendations V.25ter, T.31 and T.32. In GSM there can be voice
followed by data (refer to GSM 02.02), alternating voice/data (refer to
GSM 02.02) and alternating voice/fax calls (refer to GSM 02.03).
Test command returns values supported by the TA as a compound
value.
Note! +CMOD is set to zero after a successfully completed alternating mode
call. It is set to zero also after a failed answering. The power-up, factory
(&F) and user resets (Z), also set the value to zero. This reduces the
possibility that alternating mode calls are originated or answered
accidentally.
Description Command Possible Responses
Request Call Mode AT+CMOD=[] • OK
• ERROR
Show the current
setting
AT+CMOD? • +CMOD:
• OK
• ERROR
Show if the command
is supported
AT+CMOD=? • +CMOD: (list of
supported
s)
• OK
• ERROR
Description
0 Single mode. Default value.
In order to avoid accidental originating or answering of
alternating calls is set to single mode in following
cases:
- after a successfully completed alternating mode call;
- after a unsuccessful answering;
- after successfully execution of the commands &F and Z