Sony Ericsson GM47 - Manual (Page 102)

GM47/GM48 INTEGRATOR’S MANUAL
102
LZT 123 7263 R1C
3.3 ATS2 Escape Sequence Character
Defines the character to be used as the escape sequence character when
switching from on-line data mode to on-line command mode. The
response to the command is modified to reflect the change.
Note! If the parameter is set to a value in the range of 128-255, the
escape sequence detection is disabled.
3.4 ATS3 Command Line Termination Character
This S-parameter represents the decimal IA5 value of the character
recognised by the DCE from the DTE to terminate an incoming
command line. It is also generated by the DCE as part of the header,
trailer, and terminator for result codes and information text, along with
the S4 parameter.
The previous value of S3 is used to determine the command line
termination character for entry of the command line containing the S3
setting command. However, the result code issued uses the value of S3
as set during the processing of the command line. For example, if S3
was previously set to 13 and the command line “ATS3=30” is issued,
Description Command Possible Responses
Set escape sequence
character
ATS2=[] • OK
• ERROR
Show the current
setting
ATS2?
Show if the command
is supported
ATS2=? S2: (list of supported
s)
Description
43 Escape sequence character. Default value
0 to 255 Escape sequence character
Description Command Possible Responses
Set Command Line
Termination Character
ATS3= • OK
• ERROR
Show the current
setting
ATS3?
Show if the command
is supported
ATS3=? S3: (list of supported
s)