Sony Ericsson GM47 - Manual (Page 198)

GM47/GM48 INTEGRATOR’S MANUAL
198
LZT 123 7263 R1C
Determines the behaviour of the data set ready signal.
12.5 AT+WS46 Mode Selection
Allows an accessory to query and control the cellular protocol mode of
the phone.
12.6 ATE Command Echo
The setting of this parameter determines whether or not the DCE echoes
characters received from the DTE during command state and online
command state.
Description
0 DSR always on
1 DSR on in data mode. DSR off in command mode. Default
value
Description Command Possible Responses
Sets the cellular
protocol mode
AT+WS46=n • OK
• ERROR
Show the current
setting
AT+WS46? • OK
• ERROR
Show if the command
is supported
AT+WS46=? • (list of supported s) OK
• ERROR
parameter Description
12 This value is used for GSM at 900 Mhz., DCS-1800, and
PCS-1900 phones
Description Command Possible Responses
Request Command
Echo
ATE[]
ATE=[]
• OK
• ERROR
Show the current
setting
ATE?
Show if the command
is supported
ATE=? E: (list of supported
s)
Description
0 DCE does not echo characters during command state and
online command state
1 DCE echoes characters during command state and online
command state. Default value