Sony Ericsson GM47 - Manual (Page 25)

25
LZT 123 7263 R1C
1. Introduction
1.1 Overview
The developer’s kit is designed to get you started quickly. It contains all
the hardware you will need to begin the development of an application.
The only items you need to provide are; a computer or micro controller,
a SIM card and network subscription, and a knowledge of programming
with AT commands.
Note! Before connecting up and using the developer’s kit, we strongly
recommend you read “Part 3: Integrating the Module”, page 37 and all
of this section. There are many switches, jumpers and connector options
in the developer’s kit. A knowledge of the functionality of the GM47
module is therefore essential before you start altering the hardware
settings.
The main hardware in the developer’s kit is a screened box, containing
a board onto which you plug the GM47 module. Connectors, switches,
jumpers and SIM card holder are provided to allow you to configure and
access all the functions of the module.
1.2 Contents of the Kit
Please take the time to check the contents of your kit against the list
shown below. If any of the items are missing contact your supplier
immediately.
Developer’s kit - Part Number DPY 102 218
Contents:
Description Product Number Qty
Radio modem:
GM47 module or
GM48 module
DPY 102 201
DPY 102 204
1
GM47/GM48 developer’s kit (screened
box and development board)
KRY 101 1907 1
Switched mode PSU 12V d.c. EPA-121DA-12 1
UK mains plug EN90POWERLEADUK 1
European mains plug EN90POWERLEADEU 1