Sony Ericsson GM47 - Manual (Page 257)

15. SHORT MESSAGE SERVICES - POINT TO POINT
257
LZT 123 7263 R1C
15.7 AT+CMGS Send Message
PDU Mode
Sends a message from a TE to the network (SMS-SUBMIT). Message
reference value is returned to the TE on successful message
delivery. Optionally, when AT+CSMS value is 1 and there is
network support, is returned. Values can be used to identify
message upon unsolicited delivery status report result code. If sending
fails in a network or an ME error, final result code +CMS ERROR:
is returned. This command is abortable.
• must indicate the number of octets coded in the TP layer
data unit to be given (i.e. SMSC address octets are excluded).
• The TA shall send a four character sequence
(IRA 13, 10, 62, 32) after
command line is terminated with ; after that PDU can be given
from TE to ME/TA.
• The DCD signal is in the ON state as PDU is given.
• The echoing of given characters back from the TA is controlled by
V.25ter echo command E.
• The PDU shall be hexadecimal format (similarly as specified for
) and given in one line; ME/TA converts this coding into the
actual octets of PDU.
• When the length octet of the SMSC address (given in the )
equals zero, the SMSC address set with command Service Centre
Address +CSCA is used.
• Sending can be cancelled by giving character (IRA 27).
• (IRA 26) must be used to indicate the ending of PDU.
Description
Integer type Value in the range of location numbers supported by the
associated memory
Description Command Possible Responses
Send message AT+CMGS=
PDU is given
ESC>
• +CMGS:
[,]
• +CMS ERROR:
• OK
• ERROR
Show if the command
is supported
AT+CMGS=? • OK
• ERROR
Description
Integer type GSM 03.40 TP-Message-Reference in integer format