Sony Ericsson GM47 - Manual (Page 158)

GM47/GM48 INTEGRATOR’S MANUAL
158
LZT 123 7263 R1C
6.2 AT+CGATT GPRS Attach or Detach
Used to attach the MS to, or detach the MS from, the GPRS/packet
domain service. After the command has completed, the MS remains in
V.250 command state. If the MS is already in the requested state, the
command is ignored and the OK response is returned. If the requested
state cannot be achieved, an ERROR or +CME ERROR response is
returned. Extended error responses (enabled by the +CMEE command)
are listed under “+CME ERROR (Mobile Equipment Error Code)”,
page 85.
Any active PDP contexts will be automatically deactivated when the
attachment state changes to detached.
Note! This command has the characteristics of both the V.250 action and
parameter commands. Hence it has the read form in addition to the
execution/set and test forms.
Description Command Possible Responses
Attach or detach MS
to the GPRS/packet
domain/packet
domain service
+CGATT=[] • +CME ERROR:
• OK
• ERROR
Show the current
setting
+CGATT? • +CGATT:
• OK
• ERROR
Show if the command
is supported
+CGATT=? • +CGATT: (list of
supported s)
• OK
• ERROR
Description
0 Detached
1 Attached