Sony Ericsson GM47 - Manual (Page 103)

3. CONTROL AND STATUS
103
LZT 123 7263 R1C
the command line is terminated with a character (IA5 0/13), but
the result code issued uses the character with the ordinal value 30 (IA5
2/14) in place of the .
3.5 ATS4 Response Formatting Character
This S-parameter represents the decimal IA5 value of the character
generated by the DCE as part of the header, trailer, and terminator for
result codes and information text, along with the S3 parameter (see the
description of the V parameter for usage).
If the value of S4 is changed in a command line, the result code issued
in response to that command line will use the new value of S4.
Description
13 Command line termination character, Default value
0 to 127 Command line termination character
Description Command Possible Responses
Set Response
Formatting Character
ATS4= • OK
• ERROR
Show the current
setting
ATS4?
Show if the command
is supported
ATS4=? S4: (list of supported
s)
Description
10 Formatting character. Default value
Note: ASCII character 10 is equivalent to
0 to 127 Formatting character