Sony Ericsson GM47 - Manual (Page 207)

12. INTERFACE
207
LZT 123 7263 R1C
12.16 AT*E2ESC M2M Escape Sequence Guard Time
Defines a guard time for the escape sequence in GPRS to return to on-
line command mode i.e. if +++AT is received either as part of the
data stream or a terminating string from the application and no further
data is received for the duration of the guard time the module will go
into on line command mode. This guards against the module
accidentally going into on line command mode. The verbose format of
+++AT is AT.
Description
0 Sync Pin initial state LOW
1 Sync Pin initial state HIGH
, Description
0-255 decimal value denoting the byte value to be sent
Description
0 SPI bus is active (pins are controlled by SPI)
1 SPI bus is not active (pins are not controlled by SPI)
Description Command Possible responses
Set GPRS online
command guard time
AT*E2ESC=[] • OK
• ERROR
Show the current
setting
AT*E2ESC? *E2ESC:
Show if the command
is supported
AT*E2ESC=? • OK
• ERROR
Description
0 No guard time. Default value
1-10 Guard time in seconds