Sharp UX-600M - Manual (Page 99)

Automatic document
feeding does not work for
transmission or copying.
•
Check the size and weight of the document (see
"Transmittable documents" in Chapter 3).
Nothing is printed at the
receiving end.
•
Make sure that the document for transmission is
placed face down in the feeder.
•
Make sure that the fax paper is properly loaded
in the receiving machine.
A distorted image is
received at the other end.
•
Noise on the telephone line may cause
distortion. Try sending the document again.
•
Make a copy of the document on your fax. If the
copy is also distorted, your fax may have a
problem.
The power is on, but no
reception takes place.
•
Make sure that the telephone line cord is
plugged into the "TEL. LINE" jack, and not the
"TEL. SET" jack.
The printing paper does not
come out.
•
The printing paper may be jammed. See
"Clearing Jammed Printing Paper" in this
chapter.
•
Make sure that the printing paper is properly
loaded in your machine.
The printing paper comes
out blank when you try to
receive a document.
•
Make sure that the document is loaded properly
in the feeder of the transmitting machine. Make
a copy to confirm the printing ability of your
machine.
The received document is
faint.
•
Ask the other party to send higher contrast
documents. If the contrast is still too low, your
fax may have a problem. Make a copy to check
it.
Received images are
distorted.
•
Noise on the telephone line may cause
distortion. Have the other party try sending the
document again.
•
The print head may be dirty. See "Fax print
head" in Chapter 11.
•
Make a copy of another document on your fax. If
the copy is also distorted, your fax may have a
problem.
Chapter 12 Troubleshooting
87