Quick reference guide, Receiving documents, Loading paper – Sharp UX-600M User Manual

Page 5: Installing the imaging film

Receiving Documents

Press the

RECEPTION

MODE

key until "AUTO"

or "MANU" appears in the
display.

RECEPTION

MODE

AUTO reception: The fax will automatically an-
swer after four rings and receive the incoming
document.

MANUAL reception: Lift the handset when the
fax rings. If you hear a fax tone, wait until
RECEIVING appears in the display, then hang
up (if RECEIVING doesn’t appear, press the

START

key). If the calling party talks to you,

press your

START

key to begin reception.

(See Pages 42-43 of your manual.)

Loading paper

1. Insert the paper tray

into the fax if not yet in-
stalled.

2. Remove the paper

cover if it is on the tray.
(For legal paper, flip up
the tray externder.)

3. Pull the paper release

plate toward you.

♦

If any paper remains
in the tray, take it out
and combine it into a
single stack with the
new paper.

4. Insert the stack of

paper into the tray.
Replace the tray
cover and then push
the paper release
plate back down.

5. Press the following sequence of keys:

Press "

" if you loaded letter size paper, or

" if you loaded legal size paper.

When finished, press:

(See pages 13-14 of your manual.)

Installing the imaging film

FUNCTION

STOP

1. Press the release

marked

OPEN

and

open the print com-
partment cover.

2. Insert two of the

gears into the ends
of the spool with film.

3. Hold the empty spool

so that the end with
only one slot is on the
left, and lower the
spools into the printing
compartment so that
the gears fit into the
slots on each side of
the compartment.

4. Cut the band holding

the spools together
with scissors, and re-
move it. Insert the re-
maining gear into the
right end of the
empty spool and the
flange into the left
end of the empty
spool.

5. Pull the empty spool to-

ward the back of the
compartment, unwind-
ing the leader from the
spool with film. Insert
the empty spool into
the compartment so
that the gear and spool
fit into the slots on
each side of the com-
partment.

6. Wind the film slightly

to remove slack and
then close the
printer compartment
cover.

7. If you replaced the film, press the following

sequence of keys (this is not necessary for
the sample film included with the fax):

(See Pages 2-5 of your operation manual.)

FUNCTION

START

LEGAL

LETTER

Quick Reference Guide