Sharp UX-600M - Manual (Page 20)

Connecting the fax to your computer
The Multifunction Interface kit which comes with your fax machine allows you
to use your fax as a printer and scanner, and lets you perform fax operations
from your computer via the fax modem in your fax machine. Follow the steps
below to connect the PC Interface box and cables.
Important:
Use only the provided interface cable and modular plug cable.
1
Make sure that your fax is unplugged and the power switch is turned off on
your computer.
2
Insert the female end of the interface cable into the serial (RS232C) port on
your computer. Tighten the screws with a screwdriver.
3
Insert the male end of the interface cable into the port on the PC Interface
box. Tighten the screws with a screwdriver.
4
Insert one end of the modular plug cable into the jack on the PC Interface
box, and the other end into the jack on your fax as shown (the ends of the
cable are identical).
Modular
plug cable
PC Interface
box
Interface cable
Computer
Chapter 1 Installation
8