Sharp UX-600M - Manual (Page 88)

Setting 9: TAD CONNECTED
Press "1" (YES) if an answering machine is connected to the fax and turned on,
or "2" (NO) if not. See Chapter 7 for more details on using an answering
machine hookup.
(Note: Select "NO" if you are using the distinctive ring function.)
•
Initial setting: "2"
Setting 10: QUIET DETECT TIME
This sets the duration of silence (in seconds) after which the fax will take over
the line and begin reception when an answering machine is connected. Enter a
number from "01" to "10", or enter "00" to turn off the function. (This setting
is described in more detail in "Optional Hookup Settings" in Chapter 7.)
(Note: We recommend that you do not set Quiet Detect Time below 3 seconds.)
•
Initial setting: "04"
Setting 11: FAX RECEPTION WHEN TAD FAILS
Press "1" (YES) to have the fax answer a call if an answering machine
connected to the fax does not answer within 5 rings. Press "2" (NO) to turn the
function off. (This setting is described in more detail in "Optional Hookup
Settings" in Chapter 7.)
• Initial setting: "2"
Setting 12: DISTINCTIVE RING
This sets the ring pattern to which your fax will answer if you subscribe to a
distinctive ring service. Enter a number from "1" to 5" to select a pattern. See
"Distinctive Ring" in Chapter 2 for more details.
•
Initial setting: "5"
Setting 13: FAX SIGNAL RECEIVE
Your fax is set to automatically begin reception if you hear a high-pitched fax
tone after answering a call on your fax or an extension phone. If you use a
computer fax modem to send documents on the same line, you must turn this
setting off in order to prevent your fax from mistakenly attempting to receive
documents from the computer fax modem. Press "1" to turn the setting on, or
"2" to turn it off.
•
Initial setting: "1"
Chapter 9 Optional Settings
76