Sharp UX-600M - Manual (Page 92)

Reception errors
E-0 Able to recognize handshake signal, but it has errors.
E-1 Line disconnected during reception.
E-2 Cannot recognize the handshake signal from the transmitter side.
E-3 Cannot recognize the last handshake signal from the transmitter side.
E-4
Cannot recognize the handshake signal for next page from the transmitter side in
the case of mode change.
E-5 Cannot recognize the handshake signal for next page from transmitter side.
E-7 No response from transmitter or "disconnect signal" is received at receiver side.
E-8 Error occurred upon completion of reception of all pages.
E-9
Error occurred when mode was changed or transmission/reception switching was
performed.
E-10 Error occurred during partial page or physical page reception.
E-11
Error occurred after or during inquiry from the remote (transmitting) machine as to
whether reception was possible or not.
E-12 Error occurred during or just after fallback.
E-13 Error occurred after retransmission end command was received.
E-14 Error occurred after voice communication command was received.
Timer list
This list shows the timer operations which are currently set.
Chapter 10 Printing Reports and Lists
80