Sharp UX-600M - Manual (Page 18)

UX600MU-ISCO DD
Connections
Connect the power cord, telephone line cord, and handset as shown below. If de-
sired, you can also connect an answering machine or an extension telephone to
your fax.
♦
Connecting an answering machine to the fax will allow you to receive both
voice and fax messages on the same line while you are out. For details on
using this feature, see Chapter 7. (Note: Do not connect an answering ma-
chine to your fax if you will be using the distinctive ring feature described
in Chapter 2.)
♦
You can connect an extension phone to the fax to make and receive calls
like any other extension phone on your line. For details on receiving faxes
from an extension phone, see Chapter 4, "Receiving Documents".
1
Plug the power cord into a 120 V,
60 Hz, grounded (3-prong) outlet.
Caution: Do not plug the power
cord into any other kind of outlet.
This will damage the machine and
is not covered under the warranty.
2
To connect an answering machine
or extension phone to the fax, first
remove the seal covering the TEL.
SET jack on the fax, and then insert
the line for the answering machine
or the extension phone into the
TEL. SET jack. For an answering
machine, the other end of the line
should be connected to the answer-
ing machine’s telephone line jack,
not its extension phone jack.
TEL.
LINE
EXT.
PHONE
If desired, you can connect an answering
machine to the fax first, and then connect
an extension phone to the answering ma-
chine’s extension phone jack.
AC outlet
Answering
machine
Extension
telephone
Chapter 1 Installation
6