Samsung CLP-510 Series - Manual (Page 232)

C.9
C
An IP address consists of 4 bytes.
12 Press the scroll button ( or ) to enter a number
between 0 and 255 and press the Enter button ( ).
13 Repeat step 12 to complete the address from the 1st byte
to the 4th byte.
14
To select other parameters, such as the Subnet Mask or
Gateway, press the scroll button ( or ). Press the
Enter button ( ).
15 Repeat steps 12 through 13 to configure the other TCP/IP
parameters.
16 Press the On Line/Continue button ( ) to return to
ready mode.
Dynamic Addressing (BOOTP/DHCP)
To assign the TCP/IP address automatically by the server, take
the following steps:
1 In ready mode, press the Menu button ( ) until you see
“Network” on the bottom line of the display. Press the Enter
button ( ) to access the menu.
2 Press the Enter button ( ) when “Config Network”
displays on the bottom line.
3 Press the scroll button ( or ) until “Yes” displays, and
press the Enter button ( ).
4
Press the Upper Level button ( ), then use the scroll
button ( ).
5 Press the Enter button ( ) when “Config TCP” displays.
6 Press the scroll button ( or ) until “Yes” displays, and
press the Enter button ( ).
Enter a number between 0
and 255 for each byte.
U
SING
Y
OUR
P
RINTER ON A
N
ETWORK