Samsung CLP-510 Series - Manual (Page 230)

C.7
C
Printing a Network Configuration Page
The Network Configuration page shows how the network
interface card on your printer is configured. The default settings
which are suitable for most applications are enabled.
1 In ready mode, press the Menu button ( ) until you see
“Network” on the bottom line of the display.
2 Press the Enter button ( ) to access the menu.
3 Press the scroll button ( or ) until “Print Net CFG”
displays on the bottom line.
4 Press the Enter button ( ).
The Network Configuration page prints out.
Setting Network Protocols
When you first install the printer, all supported network protocols
are enabled. If a network protocol is enabled, the printer may
actively transmit on the network even when the protocol is not in
use. This may increase network traffic slightly. To eliminate
unnecessary traffic, you can disable unused protocols.
1 In ready mode, press the Menu button ( ) until you see
“Network” on the bottom line of the display. Press the Enter
button ( ) to access the menu.
2
Press the Enter button ( ) when “Config Network”
displays on the bottom line.
3 Press the scroll button ( or ) until “Yes” displays, and
press the Enter button ( ). Then press the Upper Level
button ( ).
4 Press the scroll button ( or ) until you see the desired
protocol on the bottom line.
You can choose between “Config TCP” and “Netware”.
5 Press the Enter button ( ).
6 Press the scroll button ( or ) to change the setting.
If you selected “Config TCP”, change the setting to “No”
(disable) or “Yes” (enable).
If you selected ‘Netware’, change the setting to “Off”
(disable) or “On” (enable).
7 Press the Enter button ( ) to save the selection.
8
Press the On Line/Continue button ( ) to return to
ready mode.
U
SING
Y
OUR
P
RINTER ON A
N
ETWORK