Samsung CLP-510 Series - Manual (Page 193)

S OLVING P ROBLEMS
7.26
Understanding Display Messages
Messages appear on the control panel display to indicate the
printer’s status or errors. Refer to the tables below to
understand the messages’ meaning and correct the problem if
necessary. Messages and their meanings are listed in
alphabetical order.
N OTE : When you call for service, it is very helpful to tell the
service representative the display message.
Curl If the printed paper is curled or paper does not feed into the
printer:
• Turn the stack of paper over in the paper tray. Also try rotating
the paper 180° in the tray.
Problem Solution
Message Status Do this...
ADC Not
Confirm Error
A problem has occurred in
the ADC in the printer.
Contact a service representative.
Cover Open The top cover is open. Close the top cover firmly.
[Color] Toner
Empty
The corresponding toner
cartridge in your printer is
empty and the printer
working.
Replace the corresponding toner
cartridge with a new one. See
page 6.8.
Dev. Motor
Error
A problem has occurred in
the development motor of
the printer.
Unplug the power cord and plug it in
again. If the problem persists, call for
service.
Engine Fuser
Low Heat Error
The temperature in the
fuser is abnormally low.
Unplug the power cord and plug it in
again. If the problem persists, call for
service.
Engine Fuser
Over Heat Error
The temperature in the
fuser is abnormally high.
Unplug the power cord and plug it in
again. If the problem persists, call for
service.