Sample file modem_f0.cfg – IBM RS/6000 44P User Manual

Page 202

timeout 60

done

page:

send "ATDT%N,,,,%R;\r"

# %N = pager call center number

# Add enough commas to wait for

# time to enter paging number.

# %R = paging number

# Confirm successful command.

expect "0\r" timeout 60

delay 2

# Wait before hanging up.

send "ATH0T\r"

# Hang up.

expect "0\r" timeout 2

# Confirm successful command.

done

ripo:

send "AT&FQ0T\r"

# Reset to factory defaults.

ignore "0\r" or "OK\r\n" timeout 2 # Ignore modem response.

send "ATE0T\r"

# Initialize modem: Echo OFF,

expect "0\r" or "OK\r\n" timeout 2 # Enable responses (Numeric),

send "ATQ0V0X0T\r"

# Limit response codes.

expect "0\r" timeout 2

# Confirm commands successful.

send "ATS0=0\r"

# Set AutoAnswer OFF

expect "0\r" timeout 2

# Confirm command successful.

send "AT&C1&D2\r"

# Detect carrier and DTR.

expect "0\r" timeout 2

# Confirm command successful.

done

# RI Power On enabled.

error:

# Handle unexpected modem

# responses.

expect "8\r" or "7\r" or "6\r" or "4\r" or "3\r"

delay 2

done

Sample File modem_f0.cfg

# COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F0

# FUNCTIONS: Modem configuration file for many recent Hayes* compatible modems.

# This example uses the AT&F0 reset command to choose the factory defaults.

# This set up is preferred for modems with extended (&) commands. For early

# vintage modems, setup Z or Z0 is recommended. If your modem responds to

# the extended (&) commands and to factory default choices (&Fn), but doesn't

# work properly with this setup file, setup F1 is recommended.

# * Trademark of Hayes Microcomputer Products, Inc.

# Licensed Materials - Property of IBM

# US Government Users Restricted Rights - Use, duplication or

# disclosure restricted by GSA ADP Schedule Contract with IBM Corp.

# If the modem has configuration switches, they should be set to the

184

44P Series Model 170 User’s Guide