IBM RS/6000 44P User Manual
Page 102
If you type the password incorrectly, press the Esc key and start again.
If the two password entries do not match, an error icon displays with a message:
Password was attempted to be set
and an error code
Privileged Access: 20E00001
displays.
If you previously had set a privileged-access password and want to remove it, select
the Remove icon.
After you have selected the remove icon. The privileged-access status icon flashes and
changes to the unlock position to indicate that the privileged-access not set.
Note: After you have entered and verified the password, the privileged-access
password icon flashes and changes to the locked position to indicate that your
system unit now requires the password that you just entered before running
system programs.
Attention:
If no user-defined bootlist exists and the privileged-access password has
been enabled, you are asked for the privileged-access password at startup every time
you boot your system.
Verify Password
84
44P Series Model 170 User’s Guide