beautypg.com

IBM RS/6000 44P User Manual

Page 100

background image

Press Enter when you are finished; you must type the password again for verification.

If the two password entries do not match, an error icon displays with a message:

Password was attempted to be set

and an error code

Power-On Access: 20E00000

displays.

Note: If you

forget

the Power-On Access password, you can erase the password by

shutting down the system unit and removing the battery for at least 30 seconds.

A password becomes effective only after the system is turned off and back on again.

Remote Mode: The remote mode, when enabled, allows the system to start from the
defined boot device. This mode is ideal for network servers and other system units that
operate unattended. When the remote mode is set, the icon label changes to Remote
.

Enter Password

Verify Password

82

44P Series Model 170 User’s Guide