IBM RS/6000 44P - Manual (Page 116)

Type the device number of the device name that you want to select as the Nth boot
device. For example, if you entered this menu by selecting 4 on the previous menu
(configure 2nd Boot Device), then enter the number 3 based on the list shown above.
You are thus selecting the SCSI CD-ROM device to be the 2nd (Nth) device in the boot
sequence.
Utilities
The Utilities screen enables you to select from the following system management tools.
Set Password and Unattended Start Mode
Entering this selection permits access to the following options.
Configure Nth Boot Device
Device Current Device
Number Position Name
1 1 Diskette
2 2 Ethernet
3 3 SCSI CD-ROM
4 4 SCSI 4.5GB Hard Disk
5 -
.------.
|X=Exit|
′------'
===>
Utilities
1 Set Passwords and Unattended Start Mode
2 SCSI Spin up
3 Display Error Log
4 Remote Initial Program Load Setup
5 Change SCSI id
6 Update System Firmware
7 Update Service Processor Firmware
8 Select Console
.------.
|X=Exit|
′------'
===>
98 44P Series Model 170 User’s Guide