IBM B50 - Manual (Page 131)

Completing the Installation
Before you begin:
Complete all the installation procedures for the options you have chosen to
install.
1. Install the cover by placing it close to the front of the server, as shown.
2. Slide the cover toward the front of the server until it is firmly in place.
3. Tighten the three thumbscrews located at the rear of the server.
4. Reinstall the server into the rack.
5. Reconnect all device cables, such as the printer and display, then plug the power
cords into properly grounded electrical outlets. Refer to the figure on page 1-7
for the specific location for each connector.
6. If you have a modem or fax machine attached to the server, reconnect the
telephone line to the server and the outlet.
What to do next?
Install any required device drivers, and update configuration information as
specified in your operating system documentation.
If the only changes you made involved a jumper setting, or security cable,
your server is now ready to use.
Chapter 4. Installing and Removing Options 4-39