IBM B50 - Manual (Page 104)

3. To enable or change the privileged-access password, first touch the metal frame
of the server, then gently pull upward on the small box (jumper) covering the
pins. Replace the jumper so that it covers the rear two pins instead of the front
two.
4. To set the privileged-access password, you must first install all other options
(such as internal drives, memory, adapters) if you are planning to install them
now. After you have installed these options, replaced the cover, and reinstalled
the server in the rack, start the System Management Services to set the
privileged-access password. For more information on the System Management
Services, see Chapter 3, “Using System Management Services.”
What to do next?
To enable or disable:
The privileged-access password, go to page 4-11.
The automatic power-up feature, go to page 4-13.
The power-on password, go to page 4-8.
The external SCSI connector, go to page 4-33.
To install:
A memory module, go to page 4-16.
An adapter, go to page 4-23.
An internal drive, go to page 4-29.
A new battery, go to page 4-36.
To remove:
An adapter, go to page 4-26.
A memory module, go to page 4-20.
An internal drive, go to page 4-29.
To complete the installation, go to page 4-39.
4-12 7046 Model B50 User's Guide