IBM B50 - Manual (Page 103)

Enabling the Privileged-Access Password
Before you begin:
Read “Safety Considerations” on page 4-2 and “Handling Static Sensitive
Devices” on page 4-3.
Remove the server cover (see “Removing the Cover” on page 4-4).
To enable the privileged-access password, you must first change the jumper on the
system board which blocks the use of the privileged-access password.
This procedure should only be performed one time.
1. Locate jumper J32 using the following illustration.
J32
2. Remove any adapters that are blocking the jumper.
Chapter 4. Installing and Removing Options 4-11