Installing fillers for usb printers – IBM TM7 User Manual
Page 45
Installing Fillers for USB Printers
1. Disconnect the power brick from the printer, if one is connected.
2. Place the display filler appropriate for the video display on the system unit. Do
not remove the knockout section unless you have an integrated video mount.
See Figure 13 on page 22.
3. If you have a short keyboard, place the keyboard filler beside the keyboard. See
4. Place the printer filler beside the display filler. Make sure you route the
keyboard cable to the side, as shown in Figure 13 on page 22.
updated March 18, 2002
Chapter 2. Installation Instructions
21
|
|
|
|
|
|
|
|
|
|