Set inter-character spacing – dbcs, Set or cancel rotated characters, Set print station parameters – IBM TM7 User Manual
Page 154
where:
n
The number of dot-spaces in the thermal print station or half-dot
spaces in the impact print station.
Default:
n = 03
Maximum:
n = 08
Remarks:
If you select double-width printing, the space to the right of each character
is doubled.
Set Inter-Character Spacing – DBCS
RS-232 Syntax:
ESC T n or X'1B;52;n'
where:
n
The number of dot-spaces in the thermal print station or half-dot
spaces in the impact print station.
Default:
n = 06
Maximum:
n = 20 hex (32 decimal)
Remarks:
If you select double-width printing, the spacing on the right side of each
character is doubled.
Set or Cancel Rotated Characters
RS-232 Syntax:
ESC V n or X'1B56;n'
where:
n=00
Cancel Rotated Characters
n=01
Set Rotated Character
n=02
Code Page 863 - Canadian-French
Default:
n = 00
Remarks:
Rotation is 90 degrees clockwise. This command is supported only in the
thermal print station.
Set Print Station Parameters
RS-232 Syntax:
ESC c 1 n or X'1B6331;n'
where:
n
Specifies the print station.
Bit #
↓ Station
updated March 18, 2002
130
SureMark DBCS User’s Guide