Chapter 2. installation instructions, Unpacking the printer, Chapter 2, “installation instructions – IBM TM7 User Manual
Page 35
Chapter 2. Installation Instructions
. . . . . . . . . . . . . . . . . . . . . . 11
Installing the SureMark Printers . . . . . . . . . . . . . . . . . . . 12
Installing for RS-232/RS-485 Communication . . . . . . . . . . . . . 12
Installing for USB Communication . . . . . . . . . . . . . . . . . 15
Using the Wall Mounting Feature . . . . . . . . . . . . . . . . . . 18
Installing the Fillers . . . . . . . . . . . . . . . . . . . . . . . 19
Installing Fillers for RS-232/RS-485 Printers . . . . . . . . . . . . . 19
Installing Fillers for USB Printers . . . . . . . . . . . . . . . . . 21
RS-232 Communication Mode Selections . . . . . . . . . . . . . . . 23
DTR/DSR Control . . . . . . . . . . . . . . . . . . . . . . 23
XON/XOFF Control . . . . . . . . . . . . . . . . . . . . . 24
Before installing a SureMark printer, be sure to read “Electronic Emission Notices”
DANGER
To avoid a shock hazard, do not connect or disconnect an y cables
or perform installation, maintenance, or reconfiguration of this
product during an electrical storm.
DANGER
To avoid shock hazard:
The power cord must be connected to a proper ly wired and
earthed receptacle.
Any equipment to which this product will be attached must also
be connected to properly wired receptacles.
Note: For translations of these safety notices, see IBM Safety Information – Read
This First, GA27–4004.
Unpacking the Printer
Note: Save all packing material and shipping containers.
1. Remove the SureMark printer from the shipping container and place it on a flat
surface.
2. Open any shipping containers of additional options and accessories to install
with the SureMark printer.
3. Carefully remove any remaining packing material and packing tape.
updated March 18, 2002
© Copyright IBM Corp. 1999,2001
11
||
||
||