beautypg.com

Rs-232 parameters, Usb connector pin assignments, Rs-232 parameters usb connector pin assignments – IBM TM7 User Manual

Page 105

background image

3

Receive

4

DTR (Not connected on 3-wire cable)

5

Signal Ground

6

DSR (Not connected on 3-wire cable)

7

Not Connected

8

Not Connected

9

Not Connected

See “Description of Models” on page 4 for the cable part number.

RS-232 Parameters

Protocol

DTR/DSR mode or XON/XOFF mode. Dip switch selectable.

Baud rate

9600 or 19 200, selectable by DIP switch

Start

1 bit

Data

8 bits

Parity None
Stop

1 bit

Table 10. 9-pin to 9-pin RS-232 Connector Layout

System Description

Printer Description

Pin 2 - Rx (input)

Pin 2- Tx (Output)

Pin 3 - Tx (Output)

Pin 3 - Rx (Input)

Pin 4 - DTR (Output)

Pin 4 - DTR (Input)

Pin 5 - Gnd

Pin 5 - Gnd

Pin 6 - DSR (Input)

Pin 6 - DSR (Output)

Pin 8 - CTS (Input)

Pin 6 - DSR (Output)

Table 11. 25-pin to 25-pin RS-232 Connector Layout

System Description

Printer Description

Pin 2 - Tx (Output)

Pin 3 - Rx (Input)

Pin 3 - Rx (Input)

Pin 2 - Tx (Output)

Pin 5 - CTC (Input)

Pin 6 - DSR (Output)

Pin 6 - DSR (Input)

Pin 6 - DSR (Output)

Pin 7 - Gnd

Pin 5 - Gnd

Pin 20 - DTR (Output)

Pin 4 - DTR (Input)

USB Connector Pin Assignments

SureMark printers contain a USB port, if the USB feature is installed. This port is on
the interface card, accessible under the printer without removing printer covers.
Connection to the port can be with either the standard USB Type B connector,
which requires a 24-volt power brick, or with the powered USB connector, which
contains 24-volt power lines within the communications cable.

The standard USB Type B connector has the following pin functions:

Pin

Signal

1

Vbus (+5 V dc)

updated March 18, 2002

Appendix B. Technical Information

81

|

|
|
|
|
|

|

||
||

This manual is related to the following products: