beautypg.com

Send checksum of flash eprom sector, Microcode tolerance (mct) information - loading – IBM TM7 User Manual

Page 146

background image

05

Sector 5 - flash storage

06

Sector 6 - DBCS character storage

07 - FF

Reserved

Purpose:

To erase the flash EPROM before downloading the data into the printer.

Remarks:

The command should only be sent to the printer when the buffer is empty
(status byte 2, bit 6). No other commands should be sent until this
command is complete.

Status byte 3, bit 7 (command complete bit) is set to show erasing is
finished and the command is complete.

The flash EPROM is guaranteed for a minimum life of 100,000 write/erase
commands by the Flash manufacturer.

Send Checksum of Flash EPROM Sector

RS-232 Syntax:

ESC

n or X'1B;22;n'

where:

n =

01

Sector 1 - downloaded graphics

02

Sector 2 - predefined messages

03

Sector 3 - user-defined impact character set

04

Sector 4 - user-defined thermal character sets

05

Sector 5 - flash storage

06

Thermal double-byte character sets

07

Impact double-byte character sets

Purpose:

To verify data integrity of the data loaded in the flash EPROM in the printer.
A 2-byte checksum is returned.

Microcode Tolerance (MCT) Information - Loading

RS-232 Syntax:

ESC M n h l or X'1B;4D;n;h;l'

updated March 18, 2002

122

SureMark DBCS User’s Guide

|
|

This manual is related to the following products: