Motorola SSETM 5000 - Manual (Page 57)

Chapter 3 Test Equipment and Service Aids
This chapter provides lists of test equipment and service aids, as well as information on field
programming equipment that can be used in programming and servicing SSE 5000 radios at all of
the three different levels of service.
3.1 Levels of Service
Level 1 service procedures, shown below, are all performed on the outside of the radio:
• Operating the radio
• Programming the radio
• Aligning the radio
• Checking radio performance
Level 2 service procedures are performed inside the radio, and include all Level 1 procedures, in
addition to:
• Disassembling and reassembling the radio
• Replacing assemblies, controls, flexes, gaskets, connectors, microphones, speakers, etc.
• Replacing boards or modules
Level 3 service procedures include all Level 1 and Level 2 procedures, in addition to:
• Replacing components on boards or modules
Table 3-1 lists the test equipment used to perform Level 1 service procedures. Table 3-2 lists the
service aids for all levels of service, and indicates the level for which each item is appropriate.
3.2 Test Equipment
The list of equipment contained in Table 3-1 includes all of the standard test equipment required for
servicing the SSE 5000 radio. The “Characteristics” column is included so that equivalent equipment
may be substituted, as needed.
Table 3-1. Test Equipment
Motorola
Model Number
Description Characteristics Application
R2670_ or
equivalent Communications
System Analyzer This monitor will substitute for
items with an asterisk (*) Frequency/deviation meter and
signal generator for wide-range
troubleshooting and alignment
Agilent 8901B or
equivalent Modulation Analyzer Transmitter parameter testing:
deviation balance and limit
R1717_, R1737_,
R1738_ or
equivalent Digital Multimeter Recommended for ac/dc voltage
and current measurements
WPLN4124_R or
equivalent Battery Optimizing
System (BOS)