6 transmitter troubleshooting, 7 encryption troubleshooting, Transmitter troubleshooting -4 – Motorola SSETM 5000 User Manual
Page 104: Encryption troubleshooting -4, Table 8-5, Transmitter troubleshooting chart -4, Table 8-6, Encryption troubleshooting chart -4
November 11, 2004
6881094C12-A
8-4
Troubleshooting: Transmitter Troubleshooting
8.6
Transmitter Troubleshooting
lists the possible causes of, and corrections for, transmitter problems.
8.7
Encryption Troubleshooting
lists the possible causes of, and corrections for, encryption problems.
Table 8-5. Transmitter Troubleshooting Chart
Symptom
Possible Cause
Correction or Test (Measurements
Taken at Room Temperature)
No RF Power Out
1. TX Power Level or Frequency
Check TX power level and frequency
programming (from tuner)
2. No Injection To Power
Amplifier
Send radio to depot
3. Antenna Switch/Connector
No Modulation;
Distorted Modulation
1. Programming
Check deviation and compensation
settings using the tuner
2. VOCON Board
Send radio to depot
Bad Microphone Sensitivity
1. Check Deviation and
Compensation
Realign if necessary
2. Microphone
Send radio to depot
No/Low signaling
(PL, DPL, MDC)
1. Programming
Check programming
2. VOCON Board
Send radio to depot
Cannot Set Deviation
Balance
RF Board
Send radio to depot
Table 8-6. Encryption Troubleshooting Chart
Symptom
Possible Cause
Corrective Action
No “
KEYLOAD
” on Radio Display When
Keyloading Cable is Attached to the Radio
Side Connector
1. Defective Keyload Cable
Send radio to depot
2. Defective Radio
Keyloader Displays “
KEY LOAD FAILURE!
”
1. Wrong Keyloader Type
Use correct keyloader
type. Refer to Keyloader
User Guide for more
information
2. Bad Keyloader
Try another keyloader
3. Defective Radio
Send radio to depot