87 9. troubleshooting, Symptom check and remedy – MITSUBISHI ELECTRIC CP700E User Manual
Page 88
87
9. Troubleshooting
Symptom
Check and Remedy
1
The stored image in the memory cannot be
enlarged to fill the maximum print area.
Is the SMALL size ink-sheet installed when selecting “S” in
“MODE : S/L”?
Or is the LARGE size ink-sheet installed when selecting “L” in
“MODE : S/L”?
→
Check the current setting. Refer to pages 31 - 32.
1
The color or picture quality is different between
the memorized image and the printed image.
1
The image on the monitor screen printed paper is
not colored correctly.
(When the VIDEO signal without color burst
signal is inputted to the unit, the image on the
monitor screen or printed image becomes
monochrome or rainbow-like colored image.)
1
The color or picture quality is different between
the image on the monitor screen and the printed
image. (When the color and picture quality are
same between the image stored in the memory
and the printed image.)
1
The set comments do not appear on the print
paper.
1
Wired remote control cannot be operated.
Is the paper size set to “N” in the size setting in SYSTEM menu?
→
Set the size to “M” or “W”. Refer to page 51.
Is the S size image printed on the L size paper?
→
Check the current setting. Refer to pages 31 - 32.
Is the print area set correctly in the USER SIZE ADJ?
→
Check the setting of the print area. Refer to pages 52 - 53.
Is the color of the image stored in the memory adjusted?
→
Adjust the color of the image stored in the memory with the
image adjustment display (COLOR ADJ). Refer to pages 45 -46.
Is the DCF set to “OFF”?
→
Set the DCF to “OFF”. Refer to page 47.
Is the image on the monitor screen adjusted?
→
Adjust the image on the monitor screen with “MON R-SUB”
and “MON B-SUB” in the SIGNAL ADJ menu in the signal
setting display. Refer to page 62.
Is the COMMENT set to “OFF”?
→
Set the COMMENT to “COM”. Refer to page 50.
Is the COMMENT inputted?
→
Input the COMMENT on the menu. Refer to page 56.
Is the plug of the remote control disconnected from its terminal
on the unit?
→
Connect the plug of the remote control to the REMOTE
terminal on the unit.
Is the wired remote control for this unit (accessory) used?
→
Use the remote control for this unit.
Is this unit operated through RS-232C interface?
→
Set “KEY MASK” to “OFF” through RS-232C interface.