beautypg.com

83 8. printing procedures (special prints), External remote 1 terminal on the rear panel – MITSUBISHI ELECTRIC CP700E User Manual

Page 84

background image

83

8. Printing Procedures (Special prints)

TIMING CHART

Input signal level : TTL

Input timing : 1 word 38.4 ms

Example: print code = 13=010011

External REMOTE 1 terminal on the rear panel

• The pin number on the positive pin is shown below.

1

External remote terminal Signal allocation Connector REMOTE 1

Pin No.

1

2

3

Function

Ground

MEMORY

BUSY

Description

Earth

Memory: When the signal becomes “LOW” from “HIGH”, the image is stored

in memory. (When the signal has been “LOW” for 60msec. or more, the image

is stored in memory.)

When “REMOTE BUSY” is set to “HIGH”

“HIGH” : The VCP cannot accept the remote signal.

“LOW” : The VCP can accept the remote signal.

The signal becomes “HIGH” in the following cases;

(1) During initialization after the VCP has been switched on

(2) For about 1 sec. after the INPUT SELECT switch has been set

(3) During displaying the menu screen

(4) When the image cannot be stored in memory

1.6 ms

0.4 ms

Input timing : Code : “0”

3.2 ms

0.4 ms

Input timing : Code : “1”

1

1

0

0

1

0

1 3 2

1

3
2